About GSM Burglar Home Alarm System

Which is better, a wireless or hardwire home security system? This is a question that’s bound to be asked by anyone considering the installation of a home security system.
Wireless systems are growing in popularity and are favorite systems of the do-it-yourself installer. That’s because they are easier to install than hard wired systems. The wireless security system doesn’t require running wires, but does require the installation of sensor boxes around doors and windows.

The Alarm System often include following parts:
Alarm Control Panel (Host)
Door/Window Magnetic Contact
Smoke Detectors
Gas Leakage Detectors
PIR Motion Detectors
Keyfob (keychain or remote controller)
Strobe Siren

Alarm Control Panel (Host): Alarm Control Panel is a wall-mounted unit where the detection devices and  wiring or wireless connected of the alarm are ultimately connected and managed. These include devices such as bells,siren, door contacts,PIR motion detectors,smoke detectors, gas detectors, etc. Typical panels are located in utility closets or access rooms.

Door/Window Magnetic Contact: Magnetic contacts are the most common sensing devices for sensing opening and closing of doors and windows. They are cheap and reliable.
Such sensors consist of two parts - A  contact that is installed on the door / window frame and an Activating magnet that is mounted on the door. The magnetic  is held in no-alarm contact position when door / window is kept closed. These are installed on a door or window in such a way that opening the door or window causes the magnet to move away from the contact switch which activates the alarm. They have proved to be a tried and tested method of monitoring any of the operable openings in the houses / apartments. These contacts are available in variety of finishes & materials. Heavy duty versions are also available for heavy doors, shutters and gates. The magnetic switches normally have both 'Normally open' & 'Normally Closed' contacts for easier integration with existing systems.

Back To Top

Smoke Detectors: Smoke detector is for detection of fire & smoke, All smoke detectors consist of two basic parts: a sensor to sense the smoke and a very loud electronic horn to wake people up. Smoke detectors can run off of a 9-volt battery.
It has been said that where there is smoke there is fire. It is even more true that where there is fire there is smoke. A fire sends little particles into the air. When these particles reach the smoke detector, they go through the little chamber where the electrons are flying from one electrode to the other. The smoke particles interfere with this flow enough to alert the microchip. The microchip is programmed to send a signal to the alarm.

Back To Top

Gas Leakage Detectors: Gas leak detectors can help you detect a natural gas leak if you can't or don't notice its smell. When the gas reach to the alarm warning degree, the Gas detectors will make buzz sounds & lights to alert people.

PIR Motion Detectors: Passive Infrared (PIR) Motion Sensors protect space by 'looking' for changes in infrared (heat) energy levels caused by movement of an intruder. The passive infrared detectors are passive devices. i.e., they do not transmit any form of energy. When a person enters and moves within the detecting zone, his body which is at its normal temperature of 98.6 degree F., radiates more (or less) thermal energy than the surroundings and such minute difference in thermal energy is detected by the PIR. In simple words, PIR keeps a picture of the heat levels in its view and keeps on comparing the new view with the stored one. In case there is any change then they activate the alarm.

Back To Top

Keyfob (keychain or remote controller): Keyfob works like the key, it can activate (arm) and diactivate (disarm) the alarm systems, more functions with the keyfob are with 4 key (Arm/Disarm/Home Arm/Panic)/buttons on keyfob to realize different functions.

Strobe Siren: Typically we call it bells, when alarm is triggered, the alarm panel will switch on the siren or strobe siren,  the siren or storbe siren will make noise and strobe lights (warning sounds & lights) to alert people or your neighbours,  also it will make the intruder stop the illegal intrusions.

Back To Top